If you have a combination boiler, this is the basic starting block from which you can build a heating control system, as simple or as sophisticated as you want.
If you have a boiler with a hot water tank this is the basic starting block from which you can build a heating control system as simple, or as sophisticated as you want.
This is the “Brains” that connects to all devices in a property and network It uses smart technology to make intelligent decisions. This is required for all solutions.
This will wirelessly take a message from the Genius Hub, to either allow hot water through to the radiator to heat up the room; or close down when that temperature is reached.
This will wirelessly take a message from the Genius Hub, to either allow hot water through to the radiator to heat up the room; or close down when that temperature is reached.
Smart Plugs are used to boost the signal in your home for the Radiator Valves, Room Sensors, Receiver Units and Room Thermostat.
This is the device that will accurately measure temperature, plus can remember each day when you enter a room so as to pre-heat that room to your preferred temperature.
The Genius Motion Sensor detects when a room has been used, enabling the system to build and update the heating schedule automatically.
The Single Channel Receiver is an add-on to the Genius Hub and can wirelessly control one zone with each receiver using its volt-free contact.
This is an add-on to the Genius Hub. Control one or two zones with each controller, which independently switches two 230v contacts.
The Electric Switch is an add-on to the Genius Hub and can wirelessly control one plumbed zone, wet underfloor heating zone or electric heater.
The Genius Room Thermostat is a sleek and stylish thermostat which provides both accurate temperature for the room it is placed in, as well as manual control of temperature.
A wired thermostat which provides both accurate temperature for the room it is placed in, as well as manual control of temperature. It also switches a zone of wet or electric underfloor heating.
An add-on for the Electric Switch or Powered Room Thermostat to add extra temperature measurement and control. capabilities
Range Extenders are a hard-wired device are used to boost the signal in your home for the Radiator Valves, Room Sensors, Receiver Units and Room Thermostats.
For systems with multiple zones of wet underfloor heating. The Genius Wiring Centre brings all the electrics together to make the control of the underfloor heating safe and simple.
The Electric Relay is an add-on to the Genius Hub and can wirelessly control one wet underfloor heating zone, AC zone or electric heater.